(Special Order No Cancel No Return) Ford Performance Parts Eco 5.0L Power Module is now available. This kit was developed to allow performance enthusiasts to install a 5.0L Gen 3 Mustang crate engine into any pre-1996 vehicle that originally had emissions equipment – including OBDI vehicles. CARB EO#: D-308-14   The Eco 5.0 Coyote Power Module teams the Mustang GT 460 horsepower 5.0L Coyote V8 with a state of the art 10 speed automatic transmission – and all the electronics and hardware to finish the installation. The engine features advances like Direct and Port Fuel Injection, Twin Independent Variable Camshaft Timing, and a lightweight plasma transferred wire arc spray aluminum engine block. Coyote Power Module simplifies both the shopping and build experience by kitting up the right parts that are matched to deliver potent performance with civilized drivability.  The engine Control Pack is truly plug and play and simplifies conversions to a modern electronically fuel injected V8 high performance engine for vehicles requiring a CARB compliant solution.   Mustang GT 5.0L Coyote Engine – M-6007-M50CAUTO  460 Horsepower @ 7,000 rpm 420 lb.-ft. Torque @ 4,600 rpm      12.0:1 Compression ratio  Aluminum block  M-8600-M50BALT  Boss alternator kit  M-11000-C50A Starter and starter Index Plate Eco 5.0 specific Control Pack with PCM calibration  M-9926-M50B Mustang Bullitt™ 87mm throttle body    M-12655-F ProCal 4 tool for module configuration  M-9603-M50 Mustang cold air intake  Factory Mustang GT 10R80 10 speed automatic transmission, flexplate, and torque convertor Factory Mustang GT 10R80 shifter Factory Mustang GT U-joint companion flange Factory Mustang GT transmission cooler and lines Left and Right Mustang catalytic converters Upstream and downstream O2 sensors  Runs on pump gas Installation hardware Coyote Crate Engine Technical Reference Guide  Click here for engine exterior dimensions